Yeah, the new bathroom extractor fan is fitted. No problem with this one, twist the bezel to remove it and unscrew the four (three in this case) retaining screws. Disconnect the wires and connect the new fan. Refit the screws and bezel and swap the halogen capsule for the LED. Job done.
The Kenwood mini mixer we use for Lucy's food developed a bare wire where it enters the cable strain. The conductor wasn't exposed, but the inner insulation was.
It's held together with two normal screws and one security screw which meant a modification to a cheap (Christmas cracker) screwdriver. The cable is soldered into a circuit board so it was out with the soldering iron to remove the old wires and re-terminate after cutting off the damaged cable. Another one done, almost as good as new.
 |
| Lucy's mini mixer. |
 |
| This is where the damage was. |
Posts
No comments:
Post a Comment